PCB Control Board for Adam Inset fires & stoves.
This PCB is used in all Adams Electric Inset & Stoves models like the Eclipse, Blenheim, Elan, Colorado, Carolina, Aviemore, Hudson, Woodhouse, Bergen and Ripon.
If your flame effect fails on your electric fire it could be the PCB or LED flame, first of all, you would need to try the PCB failing that it could be the LED light unit, if replacing the PCB does not work you may need to purchase the strip light.
If the heat on your fire does not work you may need to replace the PCB however in some circumstances you will need to buy a new heating element the PCB is normally the first thing that you would replace as that controls all the circuitry in the fire.
To change any part will require some basic D.I.Y skills. as you will be required to take either front or back panels of the fire to access parts. There will be then some tabs holding it in place and some small connectors that will need removing. You then refit the PCB board and reconnect it
For further technical advice please email: email@example.com
NOTE: PLEASE DO NOT ATTEMPT THIS IF YOU ARE NOT COMFORTABLE WITH D.I.Y and some basic electric work. PLEASE ALWAYS SWITCH OF ANY APPLIANCE AT THE MAINS WHILE ATTEMPTING ANY WORK. PLEASE NOTE ANY WARRANTY WILL BE VOIDED IF YOU WORK ON YOUR DEVICE. IF IT IS STILL WITHIN THE WARRANTY PLEASE CONTACT THE MANUFACTURE DIRECT.
HOWEVER WE RECOMMEND THAT ALL WORK IS CARRIED OUT BY A QUALIFIED ELECTRICIAN WHO WOULD BEST SUITED TO WORK ON YOU APPLIANCE